Fixed a problem in the Pocket strategy that could cause an operation to freeze and not finish.For the Engrave toolpath, improved the ordering to reduce the distance which the tool jumps when moving between letters in engraved text.Fixed excessive tool library load time with Harvey tools installed.The problem occurred in both roughing and finishing passes. Fixed an issue for Turning Profile operations in which leads were not generated at an angle with respect to the toolpath direction when "Use Fixed Lead Direction" was turned off.Added a new parameter "make sharp corners" to a profile turning toolpath to ensure that outside corners are sharp and not rounded.Avoid creating an extra tool entry when creating a new tool.Fixed a problem with the retract at the shifted position when expanding the Fine Boring cycle for the post processor.Added the ability for a grooving tool to go a specified distance below the inner radius while facing the part in a groove turning operation.When there is more than one body in the model, no automatic selection of all the bodies will be done when creating a new Setup.Installation WHAT’S NEW The following changes have been made in the current update (2019.3): HSMWorks Ultimate (formerly HSMWorks Premium).HSMWorks Premium (formerly HSMWorks Professional).This document covers all three HSMWorks products: Autodesk® HSMWorks™ 2019.3 Update Release Notes
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |